Hozelock Submersible Dirty Water & Water Butt Pump 300w 240v

Hozelock Submersible Dirty Water & Water Butt Pump 300w 240v

3 in 1 Pump

Use as a dirty water pump for draining flooded gardens, cellars etc etc..
Ideal for draining garden swimming pools & ponds..
Beat any hosepipe bans by using the hoselock water butt pump with water butts or large water containers...

A high pressure pump that allows the use of stored water in large containers & water butts. Ideal for garden hoses to power sprinklers, watering systems, spray guns etc etc. Self priming high pressure pump provides 1.1 bar pressure. Integral easy clean filter prevents damage from dirty water.

Applications:
Ideal for water butts & water containers
Emptying paddling pools
Aquapods & garden irrigation
All garden hosepipe accessories such as Sprinklers, Spray guns etc etc

Includes:
Multi use water pump
1 x Hosepipe connector outlet

Specifications:
Max lift: 11m
Max flow: 2200 Litres per hour
Power: 300w
Max Submersible depth: 8m
Max water temp: 35°
Max pressure: 1.1bar or 16psi

Note:
Does not include float switch so requires manual on / off operation.

Additional information regarding Submersible Water Pumps
Pumps with automatic float switches allow the pump to be left unattended and automatically cuts out when the water level drops below the pumps minimum. Pumps with no float switch are manual and must not be left running when the water level drops below the required minimum.

It is recommended that an RCD is always used with a submersible pump as should be the case whenever electrical products are used near water.

The maximum flow rate of a pump is directly affected by the height it has to lift the water. In general the flow rate will decrease as the lift height increases. Horizontal pumping distance is also affected use the formula Max Height - Working Height x 10 to determine the maximum horizontal distance the pump will be capable of.

Clean Water Pumps:
Generally clean water pumps are suitable for the drainage of cellars, sinks, cisterns, pools, baths and other general transfer of water. They are not suitable for outside ponds or other dirty water as they will only usually allow small particles to pass through. Most clean water pumps will allow suction to a very low level (normally within 5 - 10mm) before they cut out but remember this only applies if they have a float switch.

Dirty Water Pumps:
These are suitable for the drainage of most water types as they allow for a much larger particle types. Be aware however that they will usually drain water down to a level of between 25 - 50mm depending on the particle size that they allow for. Automatic cut out only applies if they have a float switch. Unless specified dirty water pumps are not suitable for agriculture type use or for drainage of water containing salt or other chemicals. The term 'dirty' in most cases applies to 'water contains small particles such as grit, sand, mud and small pebbles'.

Important:
Most submersible pumps require a lay flay hose which has a wider diameter than garden hose in order to drain the water without damaging the pump, to allow for particles (if applicable) and to allow for fast flow rates.

Help with this product...

• Warranty Information
• What are the postage costs for this item?
• What does the availability information mean?